User Manual

TI PROPRIETARY T E X A S I N S T R U M E N T S
INFORMATION -
Revision:
Strictly Private R F I D SYSTEMS
0
S P E C I F I C A T I O N
Reader Test Control Software Document Page 3 of 7 XX-XX-XX-XXX
Printed copies are not controlled documents - verify the correct revision before use.
1. Purpose
The purpose of this document is to demonstrate the Test Control
software for the RX-STU-ETR1-00 reader unit.
2. Hardware Test Set up
Connect the reader unit under test as shown in Figure 1 below.
Figure 1: Hardware Set up
Figure 2: Reader RS232, RS485 and Power Connectors
3. Test Software
Select the TR Tool Software Icon on the PC to start the Reader Control
software.
Connector
RJ45 Male
Connector,
DB9F
Cable, Assembly
RS232C PC to RJ45
PC Comm Port, DB9M
PC with
Reader
Test
Software
RS232
RS485
+5 Volts
DC
Power
Connector
RJ45 Male
Power Supply
Phi Hong
PSC15A-050S (TI)
No Connection
RFID Reader Assembly
Transceiver
IC
System
Microcontroller
2 Inches
RFID Tag
4 feet