User Manual

ManualsBrandsTexas Instruments ManualsElectronicsRFID Reader

TI PROPRIETARY T E X A S I N S T R U M E N T S

Originator:

INFORMATION - C. Bohren

Strictly Private R F I D SYSTEMS

S P E C I F I C A T I O N

Revision: 0

Reader Test Control Software Document Page 1 of 7 XX-XX-XX-XXX

Subco/Mfg

Reader Test Control Software Document

RX-STU-ETR1-00

PRINTED COPIES OF THIS SPECIFICATION

ARE NOT CONTROLLED DOCUMENTS.

VERIFY THEIR CORRECT REVISION BEFORE USE.

Proprietary Information

Confidential

Summary of content (7 pages)

PAGE 1
TI PROPRIETARY INFORMATION Strictly Private Originator: C. Bohren TEXAS INSTRUMENTS R F I D SYSTEMS SPECIFICATION Subco/Mfg Reader Test Control Software Document RX-STU-ETR1-00 PRINTED COPIES OF THIS SPECIFICATION ARE NOT CONTROLLED DOCUMENTS. VERIFY THEIR CORRECT REVISION BEFORE USE.
PAGE 2
TI PROPRIETARY INFORMATION Strictly Private TEXAS INSTRUMENTS R F I D SYSTEMS SPECIFICATION TABLE OF CONTENTS Revision: 0 PAGE 1. Purpose..............................................................................................................3 2. Hardware Test Set up.......................................................................................3 3. Test Software ....................................................................................................3 3.1 Software Icon ...
PAGE 3
TI PROPRIETARY INFORMATION Strictly Private 1. TEXAS INSTRUMENTS Revision: 0 R F I D SYSTEMS SPECIFICATION Purpose The purpose of this document is to demonstrate the Test Control software for the RX-STU-ETR1-00 reader unit. 2. Hardware Test Set up Connect the reader unit under test as shown in Figure 1 below.
PAGE 4
TI PROPRIETARY INFORMATION Strictly Private 3.1 TEXAS INSTRUMENTS R F I D SYSTEMS SPECIFICATION Revision: 0 Software Icon Figure 3: Software Icon on PC desktop 3.2 Initial Start Screen Press “Connect Button” with Left mouse button to start reader communication with the PC. Figure 4: Initial Start Screen 3.
PAGE 5
TI PROPRIETARY INFORMATION Strictly Private TEXAS INSTRUMENTS R F I D SYSTEMS SPECIFICATION Revision: 0 Figure 5: RS232 / RS485 Communication successful 3.4 Test Start 1) 2) 3) 4) Press “Start Test” Button Unit Serial Number Box Appears Enter 4 digit unit Serial Number Press “OK” Button Figure 6: Test Start Reader Test Control Software Document Page 5 of 7 XX-XX-XX-XXX Printed copies are not controlled documents - verify the correct revision before use.
PAGE 6
TI PROPRIETARY INFORMATION Strictly Private 3.5 TEXAS INSTRUMENTS Revision: 0 R F I D SYSTEMS SPECIFICATION Test Completion If the test box of Figure 7 below appears Test is successful. Figure 7: Test Completion Note: The reader unit transmitter remains in the “ON” state after successful test completion. Reader Test Control Software Document Page 6 of 7 XX-XX-XX-XXX Printed copies are not controlled documents - verify the correct revision before use.
PAGE 7
TI PROPRIETARY INFORMATION Strictly Private 4. TEXAS INSTRUMENTS Revision: 0 R F I D SYSTEMS SPECIFICATION Exploded View of Reader Assembly Assembly, Antenna Assembly, Stand Assembly, Base Plate Mount Pan Head Screw, 4-40x3/8 Foam Bumper Disk, Rubber 1/8” THK, 2” Dia. Figure 8: Exploded View of Reader Assembly 5. Revision History Rev. SCN 0 Description of Change New Issue Reader Test Control Software Document Date submitted 01/10/2003 Page 7 of 7 By C.