User's Manual

Jumper JP2
Open to measure current
Jumper JP1
Open to disconnect LED
LED D1 connected to P5.1
Jumper JP3
1-2 (int): Power supply via JTAG interface
2-3 (ext): External Power Supply
Jumper JP4 to JP9:
Close 1-2 to debug in Spy-Bi-Wire mode
Close 2-3 to debug in 4-wire JTAG mode
Orient Pin 1 of Device
www.ti.com MSP-TS430PM64A
Figure B-32. MSP-TS430PM64A Target Socket Module, PCB
79
SLAU278I–May 2009–Revised May 2012 Hardware
Submit Documentation Feedback
Copyright © 2009–2012, Texas Instruments Incorporated