User's Manual

Connector J5
External power connector
Jumper J3 to ‘ext’
Jumper JP1
Open to measure current
Jumpers JP5 to JP10
Close 1-2 to debug in
Spy-Bi-Wire mode.
Close 2-3 to debug in
4-wire JTAG mode.
Jumper JP2
Open to disconnect LED
LED connected to P1.0
Jumper JP3
1-2 (int): Power supply via JTAG debug interface
2-3 (ext): External power supply
www.ti.com MSP-TS430PZ5x100
Figure B-54. MSP-TS430PZ5x100 Target Socket Module, PCB
115
SLAU278I–May 2009–Revised May 2012 Hardware
Submit Documentation Feedback
Copyright © 2009–2012, Texas Instruments Incorporated