User's Manual

Jumper JP2
Open to disconnect LED
Connector J5
External power connector
Jumper JP3 to "ext"
Jumpers JP5 to JP10
Close 1-2 to debug in Spy-Bi-Wire mode
Close 2-3 to debug in 4-wire JTAG mode
D1 LED connected to P1.0
If the system should
be supplied via LDOI (J6),
close JP4 and
set JP3 to external
Orient Pin 1 of MSP430 device
MSP-TS430RGC64B www.ti.com
Figure B-34. MSP-TS430RGC64B Target Socket Module, PCB
82
Hardware SLAU278I–May 2009–Revised May 2012
Submit Documentation Feedback
Copyright © 2009–2012, Texas Instruments Incorporated