Datasheet

■ BOR bit in the Reset Cause (RESC) register, System Control offset 0x05C. This bit is
set only if either of the BOR events have been configured to initiate a reset. See page 274.
In addition, the following bits control both BOR events:
■ BORIM bit in the Interrupt Mask Control (IMC) register, System Control offset 0x054.
■ VDDA_UBOR0 and VDD_UBOR0 bits in the Power-Temperature Cause (PWRTC) register.
Please refer to “System Control” on page 227 for more information on how to configure these
registers.
Figure 30-4 on page 1951 shows the relationship between V
DDA
, POK, POR and a BOR event.
Figure 30-4. Power and Brown-Out Assertions vs V
DDA
Levels
P1
VDDA
P5
RISE
P4
PORPOKBOR
P4
1
VDDA
MIN
1
1
0
0
0
P6
30.6.2 V
DD
Levels
The V
DD
supply has two monitors:
■ Power-OK (POK)
■ Brown Out Reset (BOR)
The POK monitor is used to keep the digital circuitry in reset until the V
DD
power supply is at an
acceptable operational level. The digital reset is only released when the Power-On Reset has
deasserted and all of the Power-OK monitors for each of the supplies indicate that power levels are
1951June 18, 2014
Texas Instruments-Production Data
Tiva
™
TM4C129ENCPDT Microcontroller