Datasheet

Factory Set Switch Settings and Jumpers Default Configuration

www.ti.com

Figure 2-7. Switch S1: Default settings on Deserializer Board

Table 2-1. Switch S1: Deserializer Board

Switch reference Default Setting Function

High: Deserializer is enabled and is ON.

Low: Deserializer is in Sleep (power down mode). In this mode,

S1.1-PDN High

programmed control register data are NOT retained and reset to

default values.

High: BIST Mode Enabled

S1.2-BISTEN Low

Low: BIST Mode Disabled

S1.3-OEN

High Refer table on "Output States" in the device datasheet

S1.4-OSS SEL

High: RIN1+/- input is selected as the active channel on the

Deserializer.

S1.5-SEL High

Low: RIN0+/- input is selected as the active channel on the

Deserializer.

S1.6-RES

Low Reserved and must be set Low always.

S1.7-RES

Board Setup Details SNLU135–JUNE 2013

Submit Documentation Feedback