Datasheet

DRV8412
DRV8432
SLES242C –DECEMBER 2009–REVISED MAY 2010 www.ti.com
This integrated circuit can be damaged by ESD. Texas Instruments recommends that all integrated circuits be handled with
appropriate precautions. Failure to observe proper handling and installation procedures can cause damage.
ESD damage can range from subtle performance degradation to complete device failure. Precision integrated circuits may be more
susceptible to damage because very small parametric changes could cause the device not to meet its published specifications.
ABSOLUTE MAXIMUM RATINGS
Over operating free-air temperature range unless otherwise noted
(1)
VALUE
VDD to GND –0.3 V to 13.2 V
GVDD_X to GND –0.3 V to 13.2 V
PVDD_X to GND_X
(2)
–0.3 V to 70 V
OUT_X to GND_X
(2)
–0.3 V to 70 V
BST_X to GND_X
(2)
–0.3 V to 80 V
Transient peak output current (per pin), pulse width limited by internal over-current protection circuit. 16 A
Transient peak output current for latch shut down (per pin) 20 A
VREG to AGND –0.3 V to 4.2 V
GND_X to GND –0.3 V to 0.3 V
GND to AGND –0.3 V to 0.3 V
PWM_X to GND –0.3 V to 4.2 V
OC_ADJ, M1, M2, M3 to AGND –0.3 V to 4.2 V
RESET_X, FAULT, OTW to GND –0.3 V to 7 V
Maximum continuous sink current (FAULT, OTW) 9 mA
Maximum operating junction temperature range, T
J
-40°C to 150°C
Storage temperature, T
STG
–55°C to 150°C
(1) Stresses beyond those listed under Absolute Maximum Ratings may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under Recommended Operating
Conditions is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) These voltages represent the dc voltage + peak ac waveform measured at the terminal of the device in all conditions.
RECOMMENDED OPERATING CONDITIONS
MIN NOM MAX UNIT
PVDD_X Half bridge X (A, B, C, or D) DC supply voltage 0 50 52.5 V
GVDD_X Supply for logic regulators and gate-drive circuitry 10.8 12 13.2 V
VDD Digital regulator supply voltage 10.8 12 13.2 V
I
O_PULSE
Pulsed peak current per output pin (could be limited by thermal) 15 A
I
O
Continuous current per output pin (DRV8432) 7 A
F
SW
PWM switching frequency 500 kHz
R
OCP_CBC
OC programming resistor range in cycle-by-cycle current limit modes 24 200 kΩ
R
OCP_OCL
OC programming resistor range in OC latching shutdown modes 22 200 kΩ
C
BST
Bootstrap capacitor range 33 220 nF
T
ON_MIN
Minimum PWM pulse duration, low side 50 nS
T
A
Operating ambient temperature -40 85
(1)
°C
(1) Depending on power dissipation and heat-sinking, the DRV8412/32 can support ambient temperature in excess of 85°C. Refer to the
package heat dissipation ratings table and package power deratings table.
2 Submit Documentation Feedback Copyright © 2009–2010, Texas Instruments Incorporated
Product Folder Link(s): DRV8412 DRV8432