Datasheet

Connectors

www.ti.com

B.2.4 CN4 – XG4C-3031 (omrom)

CN4 is a 3.3-V voltage level I/F connector, and it is used on the C2000 Control CARD.

Table 8. 3.3-V Analog and Digital I/O

Pin# Name Description

1 GND Ground

2 ISCOMP Current comparator output

3 ALV Motor current sense amp output

4 PTV3 Phase amplifier output 3

5 PTV2 Phase amplifier output 2

6 PTV1 Phase amplifier output 1

7 NC No connection

8 PRN Pulse input

9 CTLUH Pre-driver parallel input

10 CTLUL Pre-driver parallel input

11 CTLVH Pre-driver parallel input

12 CTLVL Pre-driver parallel input

13 CTLWH Pre-driver parallel input

14 CTLWL Pre-driver parallel input

15 CTLEN Pre-driver parallel enable input

16 DIN SPI data signal input

17 SCK SPI clock signal input

18 CS SPI chip select signal input

19 PSS3 Sample and hold control signal input 3 (not used)

20 PSS2 Sample and hold control signal input 2 (not used)

21 PSS1 Sample and hold control signal input 1 (not used)

22 OVCR Overcurrent reset input (not used)

23 CANTX CAN digital input (not used)

24 CANRX CAN digital output (not used)

25 FAULT Diagnosis output

26 RES Reset output

27 DOUT SPI data signal output

28 PMV3 Phase comparator output 3

29 PMV2 Phase comparator output 2

30 PMV1 Phase comparator output 1

I/F Board SLVU844–February 2013

Submit Documentation Feedback