Datasheet

C
(REG)
C
(VDD)
V
DD
REG OUT+
GND
OUTt
SDA
IN
SCL
EN
Via
Via should connect
to a ground plane
DRV2605
SLOS825C –DECEMBER 2012 –REVISED SEPTEMBER 2014 www.ti.com
10.1.1 Trace Width
The recommended trace width at the solder pins is 75 µm to 100 µm to prevent solder wicking onto wider PCB
traces. Maintain this trace width until the pin pattern is escaped then the trace width can be increased for
improved current flow. The width and length of the 75-µm to 100-µm traces should be as symmetrical as possible
around the device to provide even solder reflow on each of the pins.
10.2 Layout Example
Figure 62. DRV2605 Layout Example DSBGA
54 Submit Documentation Feedback Copyright © 2012–2014, Texas Instruments Incorporated
Product Folder Links: DRV2605