Datasheet

EN
PWM
NC OUT -
VDD
GND
OUT +
LRA / ERM
GND
GND
5
10
1
2
3
4
9
8
7
6
DRV2603
SLOS754A –JUNE 2012–REVISED JANUARY 2014 www.ti.com
These devices have limited built-in ESD protection. The leads should be shorted together or the device placed in conductive foam
during storage or handling to prevent electrostatic damage to the MOS gates.
ORDERING INFORMATION
Part Number Package Symbolization
DRV2603RUNR 10-pin, 2 mm x 2 mm x 0.75 mm, RUN 2603
DRV2603RUNT 10-pin, 2 mm x 2 mm x 0.75 mm, RUN 2603
PINOUT INFORMATION
10-PIN RUN
PIN FUNCTIONS
PIN INPUT/
OUTPUT/ DESCRIPTION
NAME NUMBER
POWER (I/O/P)
PWM 2 I Input signal
EN 1 I Device enable
LRA/ERM 3 I Mode selection
GND 5, 8, 10 P Supply ground
NC 4 I No Connection
OUT– 6 O Negative haptic driver differential output
OUT+ 9 O Positive haptic driver differential output
VDD 7 P Supply Input (2.5 V to 5.5 V)
ABSOLUTE MAXIMUM RATINGS
(1)
over operating free-air temperature range, T
A
= 25°C (unless otherwise noted)
VALUE UNIT
Supply voltage VDD –0.3 to 6.0 V
V
I
Input voltage EN, PWM, LRA/ERM –0.3 to V
DD
+ 0.3 V
T
A
Operating free-air temperature range –40 to 85 °C
T
J
Operating junction temperature range –40 to 150 °C
T
stg
Storage temperature range –65 to 150 °C
HBM 2000 V
ESD Protection
CDM 500 V
(1) Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under “recommended operating
conditions” is not implied. Exposure to absolute–maximum–rated conditions for extended periods may affect device reliability.
2 Submit Documentation Feedback Copyright © 2012–2014, Texas Instruments Incorporated
Product Folder Links :DRV2603