Datasheet

www.ti.com

INTRODUCTION

2.3.2 FG Pull Up (J2) Jumper

JP2 can be found in Figure 6. Installing the jumper will connect the FG pin of the DRV10866 to an on

board pull up resistor.

Figure 6. J2 Location

To make an external connection to FG, the jumper can be removed and pin 1 of the header provides a

direct connection to the FG pin of the DRV10866. Pin 1 of J2 is highlighted in the image below, Figure 7.

Note that if the jumper is removed, an external pull up resistor is needed for connection of FG to an

external system. For more information regarding the FG pin please refer to the datasheet of the

DRV10866.

Figure 7. Pin 1 of J2

SBVU020A–November 2012–Revised December 2012 DRV10866EVM User’s Guide

Submit Documentation Feedback