Datasheet

DP83630
SNLS335B –OCTOBER 2010–REVISED APRIL 2013 www.ti.com
Table 10-18. 100 Mb/s PCS Configuration and Status Register (PCSR), address 0x16 (continued)
Bit Bit Name Default Description
8 SD_OPTION 1, RW Signal Detect Option:
1 = Default operation. Link will be asserted following detection of valid signal level
and Descrambler Lock. Link will be maintained as long as signal level is valid. A loss
of Descrambler Lock will not cause Link Status to drop.
0 = Modified signal detect algorithm. Link will be asserted following detection of valid
signal level and Descrambler Lock. Link will be maintained as long as signal level is
valid and Descrambler remains locked.
7 DESC_TIME 0, RW Descrambler Timeout:
Increase the descrambler timeout. When set, this allows the device to receive larger
packets (>9k bytes) without loss of synchronization.
1 = 2 ms.
0 = 722 µs (per ANSI X3.263: 1995 (TP-PMD) 7.2.3.3e).
6 FX_EN Strap, RW FX Fiber Mode Enable:
This bit is set when the FX_EN strap option is selected for the respective port.
Write PHYCR2[9], SOFT_RESET, after enabling or disabling Fiber Mode via register
access to ensure correct configuration.
1 = Enables FX operation.
0 = Disables FX operation.
5 FORCE_100_OK 0, RW Force 100 Mb/s Good Link:
OR’ed with MAC_FORCE_LINK_100 signal.
1 = Forces 100 Mb/s Good Link.
0 = Normal 100 Mb/s operation.
4 RESERVED 0, RO RESERVED: Writes ignored, read as 0.
3 FEFI_EN Strap, RW Far End Fault Indication Mode Enable:
This bit is set when the FX_EN strap option is selected for the respective port.
1 = FEFI Mode Enabled.
0 = FEFI Mode Disabled.
2 NRZI_BYPASS 0, RW NRZI Bypass Enable:
1 = NRZI Bypass Enabled.
0 = NRZI Bypass Disabled.
1 SCRAM Strap, RW Scrambler Bypass Enable:
BYPASS
This bit is set when the FX_EN strap option is selected. In the FX mode, the
scrambler is bypassed.
1 = Scrambler Bypass Enabled.
0 = Scrambler Bypass Disabled.
0 DESCRAM Strap, RW Descrambler Bypass Enable:
BYPASS
This bit is set when the FX_EN strap option is selected. In the FX mode, the
descrambler is bypassed.
1 = Descrambler Bypass Enabled.
0 = Descrambler Bypass Disabled.
92 Register Block Copyright © 2010–2013, Texas Instruments Incorporated
Submit Documentation Feedback
Product Folder Links: DP83630