Datasheet

Chapter 5

DLPU006C–January 2012–Revised December 2013

Connectors

This chapter describes the connector pins of the DLP LightCrafter Module.

5.1 Trigger Connector

The trigger connector pins are listed in Table 5-1. Two matching four pin mating connector part numbers

are:

• Molex part number: 51021-0400

• Digi-Key part number: WM1722-ND

The corresponding crimps part numbers are:

• Molex part number: 50079-8000

• Digi-Key part number: WM1142CT-ND

Table 5-1. Trigger Connector Pins

DESCRIPTION PIN SUPPLY RANGE

Trigger Supply 1 3.3 V

Trigger Input 2 3.3 V

Trigger Output 3 3.3 V

Ground 4 3.3 V

5.2 Camera Connector

The camera connector pins are shown in Table 5-2. The supplies are configurable through resistor

population options between 1.8 V, 2.8 V, and 3.3 V.

Table 5-2. Camera Connector Pins

DESCRIPTION PIN SUPPLY RANGE

Camera Data[2] 1 2.8 V (CAM_IO)

Camera Data[3] 2 2.8 V (CAM_IO)

Camera Data[4] 3 2.8 V (CAM_IO)

Camera Data[5] 4 2.8 V (CAM_IO)

Camera Data[6] 5 2.8 V (CAM_IO)

Camera Data[7] 6 2.8 V (CAM_IO)

Camera Data[8] 7 2.8 V (CAM_IO)

Camera Data[9] 8 2.8 V (CAM_IO)

Camera PCLK 9 2.8 V (CAM_IO)

Digital Supply 10 1.8 V (CAM_DIGITAL)

I/O Supply 11 2.8 V (CAM_IO)

Ground 12 0 V

Analog Supply 13 2.8 V (CAM_ANALOG)

Camera VSYNC 14 2.8 V (CAM_IO)

Camera HSYNC 15 2.8 V (CAM_IO)

CLKIN 24 MHz 16 2.8 V (CAM_IO)

DLPU006C–January 2012–Revised December 2013 Connectors

Submit Documentation Feedback