Datasheet

www.ti.com

Uploading Static Images or Colors

• Resistor R205 must be installed on system boards from DLP LightCrafter hardware prior to revision

2.0.

• FPGA Firmware must be version 2.4.39 or newer

The extended pattern sequence mode follows the same steps as those listed in Section 2.8.1 for regular

internal stored pattern sequences except for selecting the pattern count. Type in the pattern count instead

of selecting an item from the drop-down list.

2.9 Uploading Static Images or Colors

To upload a 608 × 684 pixel 24-bit RGB Windows bit-mapped image (*.BMP) or display a static color,

follow these steps:

1. Set Display Mode to “Static Image / Color.”

2. Select “Static Image / Test Pattern” tab. See Figure 2-49.

Figure 2-49. DLP LightCrafter GUI Static Image and Test Pattern Tab

3. To display a 608 × 684 pixel 24-bit RGB image, click the “Browse ” button to select the BMP file and

then click the "Upload" button. See Figure 2-50.

Figure 2-50. DLP LightCrafter GUI Static Image Upload Button

4. To display a solid color enter an 8-bit value (0 to 255) for each color in the Static Color settings and

click "Set." See Figure 2-51.

• For each LED, 0 corresponds to total darkness and 255 to maximum brightness according to the

LED's current setting.

DLPU006C–January 2012–Revised December 2013 Operating the DLP LightCrafter

Submit Documentation Feedback