Datasheet

Streaming 24-bit RGB Video from the HDMI Port

www.ti.com

5. To retrieve DLP LightCrafter's current output trigger settings, click the "Get" button

2.7 Streaming 24-bit RGB Video from the HDMI Port

DLP LightCrafter can operate as a DVI-D compliant projector with its mini-HDMI connector. By default, the

EVM has the 608 x 684 EDID software installed, and supports resolutions listed in Table 2-2.

Table 2-2. Supported Resolutions for Video Input

240x320 640x480 480x852 864x480

320x240 480x720 852x480 720x240

240x427 720x480 480x853 720x288

427x240 480x752 853x480 360x640

430x640 752x480 480x853 640x360

640x430 480x800 854x480 854x480

480x640 800x480 480x854 608x684

To stream 24-bit RGB video, follow these steps:

1. Connect an active HDMI source to the mini HDMI connector.

(1)

2. Set Display Mode to “HDMI Port.”

3. Select "RGB Video Streaming (24 bits per pixel)" as shown in Figure 2-34.

Figure 2-34. DLP LightCrafter GUI RGB Video Streaming Selected on HDMI Port Tab

4. Select the frame rate.

5. Enter one of the resolutions listed in Table 2-2.

6. If the full frame is desired:

• Set Active Pixels Start to 0

• Set Active Pixels Width to the resolution width entered in step 5

• Set Active Lines Start to 0

• Set Active Lines Height to the resolution height entered in step 5

7. Click the “Set” button as shown in Figure 2-35.

(1)

The video input port is DVI-D compliant, but not HDMI compliant.

Operating the DLP LightCrafter DLPU006C–January 2012–Revised December 2013

Submit Documentation Feedback