Datasheet

Connecting to a PC www.ti.com
Figure 2-11. Ubuntu Command Terminal and "interfaces" File
4. Save the file.
5. Reboot the Linux system and run "ifconfig." See Figure 2-12.
• If "usb0" is not present, continue to step 6.
Figure 2-12. Ubuntu Command Terminal "ifconfig" Result Before USB Setup
6. Setup usb0 with IP address. See Figure 2-13.
• For example, "sudo ifconfig usb0 192.168.1.99 up"
• Choose an IP address different than the address of the LightCrafter.
7. Check that usb0 was properly assigned an IP address using "ifconfig." See Figure 2-13 .
24
Operating the DLP LightCrafter DLPU006C–January 2012–Revised December 2013
Submit Documentation Feedback
Copyright © 2012–2013, Texas Instruments Incorporated