Datasheet

www.ti.com

Connecting to a PC

2. Turn on DLP LightCrafter using the On-Off switch. A new network using the RNDIS driver should

initialize.

• The network interface on Windows systems may take a couple minutes to initialize. Please read

Section 2.2.4 to speed up the initialization.

to speed up the initialization.

3. Open the DLP LightCrafter GUI.

4. Click the "Connect" button. See Figure 2-1.

• The GUI connects to the IP address in the "Current IP Address" textbox from the "Connections"

tab. Please read Section 2.2.5 steps 7 and 8 for more details.

• After connecting, the GUI displays DLP LightCrafter's firmware versions. Select the correct tab,

according to the Display Mode, to update the GUI's tab settings to match the EVM's settings.

Figure 2-1. DLP LightCrafter GUI Connect Button

5. Click the "Disconnect" button before disconnecting the USB cable between DLP LightCrafter and the

computer. See Figure 2-2.

• The "Connect" button changes to the "Disconnect" button after a DLP LightCrafter connects.

• Unplugging the USB cable before disconnecting can cause problems when trying to reconnect to

the DLP LightCrafter if the device has not been shutdown.

Figure 2-2. DLP LightCrafter GUI Disconnect Button

DLPU006C–January 2012–Revised December 2013 Operating the DLP LightCrafter

Submit Documentation Feedback