Datasheet

Table 11-10. PSRAM Fixed Latency Wait State Configuration
RWSM/WRWSMRDWS[1:0]/WRWS[1:0]Latency in ClocksLatency Counter
00x03BCR Code 2
10x14BCR Code 3
00x15BCR Code 4
10x26BCR Code 5
00x27BCR Code 6
00x39BCR Code 8
In variable initial latency mode, the memory's WAIT (iRDY) pin guides the EPI module when to read
and write. The WAIT (iRDY) pin stalls the access for the duration of the latency and adds cycles if
there is a refresh collision. To get the best performance, set CR[13:11] = 0x2, the WRWS field of
the EPIHB16CFG register to 0x0, and the WRWSM and RDWSM bit of the EPI16TIMEn register to 0.
For the WAIT pin to be recognized correctly set the IRDYDLY bit in the EPI16TIMEn register to 1
and the CR[8] =1 in the EPIHBPSRAM register.
Note: Wait state latency works differently in PSRAM Burst mode than in other modes. In PSRAM
Burst mode the RDWS and WRWS bit fields define the latency for only the first access of the
write or read cycle. Every access after that is a single access.
Figure 11-7 on page 870 and Figure 11-8 on page 871 depict a PSRAM burst read and write.
Figure 11-7. PSRAM Burst Read
Latency (3 clocks)
DATA0 DATA1 DATA2
DATA3
EPICLK
EPI0S31
EPI0S[19:0]
ALE
CSn
RDn
WRn
EPI0S29
iRDY
EPI0S32
EPI0S[15:0]
BSELn
ADDRESS
December 13, 2013870
Texas Instruments-Advance Information
External Peripheral Interface (EPI)