Datasheet

The PROWIRE register indicates whether the 1-Wire modules are ready to be accessed by software

following a change in status of power, Run mode clocking, or reset. A power change is initiated if

the corresponding PCOWIRE bit is changed from 0 to 1. A Run mode clocking change is initiated

if the corresponding RCGCOWIRE bit is changed. A reset change is initiated if the corresponding

SROWIRE bit is changed from 0 to 1.

The PROWIRE bit is cleared on any of the above events and is not set again until the module is

completely powered, enabled, and internally reset.

1-Wire Peripheral Ready (PROWIRE)

Base 0x400F.E000

Offset 0xA98

Type RO, reset 0x0000.0000

16171819202122232425262728293031

reserved

ROROROROROROROROROROROROROROROROType

0000000000000000Reset

0123456789101112131415

R0reserved

ROROROROROROROROROROROROROROROROType

0000000000000000Reset

DescriptionResetTypeNameBit/Field

Software should not rely on the value of a reserved bit. To provide

compatibility with future products, the value of a reserved bit should be

preserved across a read-modify-write operation.

0ROreserved31:1

1-Wire Module 0 Peripheral Ready

DescriptionValue

HIM module 0 is not ready for access. It is unclocked,

unpowered, or in the process of completing a reset sequence.

1-Wire module 0 is ready for access.1

0ROR00

December 13, 2013550

Texas Instruments-Advance Information

System Control