Datasheet

Table 31-2. Signals by Pin Number (continued)
DescriptionBuffer TypePin TypePin NamePin Number
GPIO port S bit 4.TTLI/OPS4
V9
Ethernet 0 Transmit Data 0.TTLOEN0TXD0
LCD Data Pin 6 input/output.TTLI/OLCDDATA06
QEI module 0 phase A.TTLIPhA0
16/32-Bit Timer 4 Capture/Compare/PWM 0.TTLI/OT4CCP0
GPIO port T bit 1.TTLI/OPT1
V10
CAN module 0 transmit.TTLOCAN0Tx
Ethernet 0 Receive Data 1.TTLIEN0RXD1
LCD Data Pin 11 input/output.TTLI/OLCDDATA11
16/32-Bit Timer 6 Capture/Compare/PWM 1.TTLI/OT6CCP1
GPIO port G bit 2.TTLI/OPG2
V11
Ethernet 0 Transmit Clock.TTLIEN0TXCK
I
2
C module 2 clock. Note that this signal has an active pull-up. The
corresponding port pin should not be configured as open drain.
ODI/OI2C2SCL
SSI Module 2 Bi-directional Data Pin 3.TTLI/OSSI2XDAT3
GPIO port G bit 6.TTLI/OPG6
V12
Ethernet 0 Receive Error.TTLIEN0RXER
I
2
C module 4 clock. Note that this signal has an active pull-up. The
corresponding port pin should not be configured as open drain.
ODI/OI2C4SCL
1-Wire Single Bus Pin. This signal is input only if 1-Wire Alternate
Output is enabled.
TTLI/OOWIRE
SSI module 2 frame signal.TTLI/OSSI2Fss
Ethernet PHY negative receive differential input.TTLI/OEN0RXIN
V13
Ethernet PHY negative transmit differential output.TTLI/OEN0TXON
V14
Ethernet PHY positive transmit differential output.TTLI/OEN0TXOP
V15
GPIO port K bit 6.TTLI/OPK6
V16
Ethernet 0 LED 1.TTLOEN0LED1
Ethernet 0 Transmit Data 2.TTLOEN0TXD2
EPI module 0 signal 25.TTLI/OEPI0S25
I
2
C module 4 clock. Note that this signal has an active pull-up. The
corresponding port pin should not be configured as open drain.
ODI/OI2C4SCL
Motion Control Module 0 PWM Fault 1.TTLIM0FAULT1
GPIO port K bit 5.TTLI/OPK5
V17
Ethernet 0 LED 2.TTLOEN0LED2
Ethernet 0 Receive Data 2.TTLIEN0RXD2
EPI module 0 signal 31.TTLI/OEPI0S31
I
2
C module 3 data.ODI/OI2C3SDA
Motion Control Module 0 PWM 7. This signal is controlled by
Module 0 PWM Generator 3.
TTLOM0PWM7
No connect. Leave the pin electrically unconnected/isolated.--NCV18
No connect. Leave the pin electrically unconnected/isolated.--NCV19
Ground reference for logic and I/O pins.Power-GND
W1
Ground reference for logic and I/O pins.Power-GND
W2
December 13, 20132052
Texas Instruments-Advance Information
Signal Tables