Datasheet

1-1
Introduction
Introduction
The DAP Signal Conditioning Board provides data converter customers with
a general purpose analog front/back end to Data Acquisition Products
Evaluation Modules from Texas Instruments.
The signal conditioning board is compatible with the 5-6K interface board
(SLAU104), the C2000 interface board (SLAU106) and the HPA449
evaluation system from SoftBaugh, Inc. (www.softbaugh.com).
The signal conditioning board provides up to eight single ended or four
differential channels for use with a wide selection of data converter evaluation
boards. Two fundamentally equivalent varieties using either the single supply
OPA2350 or dual supply OPA2132 are available. The board contains jumpers
and additional component locations which provide a variety of configuration
options.
While the Signal Conditioning Board can serve as a stand-alone amplifier for
many applications, its primary purpose is as an interface to data acquisition
products evaluation boards. This document describes how to use the DAP
Signal Conditioning Board in conjunction with the interface boards mentioned
above.
Chapter 1