Datasheet

EVM Operation www.ti.com
7.4 Unipolar/Single-Supply Setup (Default)
Follow the configuration given in Table 11 and illustrated in Figure 5 to set up the board for single-supply
operation.
NOTE: The OFFSET_A and OFFSET_B pins must be shorted directly to GND for
unipolar/single-supply operation.
Table 11. Unipolar/Single-Supply Configuration
Jumper Position
JP3, JP4, JP5, JP6, JP7, JP9,
1-2
JP15, JP17, JP19, JP20
JP14 2-3
JP1, JP2, JP18 Open
JP8, JP16, JP11, JP13 Closed
JP10 3-4
Figure 5. DAC8728EVM Unipolar/Single-Supply Setup
14
DAC8728EVM SBAU161–February 2010
Submit Documentation Feedback
Copyright © 2010, Texas Instruments Incorporated