Datasheet

1 3
1 3
1 3
1 3
1 3
1 3
1 3
1 3
1 3
1 3
1 3
1 3
1 3
1 3
Legend: indicates the corresponding pins that are shorted or closed
3.6 Schematic
www.ti.com EVM Operation
Table 8. Jumper Setting Function (continued)
Reference Jumper Function
Setting
JMP13 Routes V
OUT
to J4-6.
Routes V
OUT
to J4-14.
JMP14 Routes V
OUT
to J4-8.
Routes V
OUT
to J4-16.
JMP15 This jumper position selects the J4A-1 pin of the output terminal, J4A, to route to the non-inverting
input of the operational amplifier, U2.
Disconnects the non-inverting input of the operational amplifier, U2, from the output terminal, J4A.
This jumper position selects the J4A-3 pin of the output terminal, J4A, to route to the non-inverting
input of the operational amplifier, U2.
JMP16 This jumper position selects the operational amplifier, U2, output pin to route to the J4A-5 output
terminal.
Disconnects the operational amplifier’s, U2, output pin from the output terminal of J4A.
This jumper position selects the operational amplifier, U2, output pin to route to the J4A-7 output
terminal.
JMP17 +5-VD (VDD) digital supply is selected for IOVDD.
+3.3-VD digital supply is selected for IOVDD.
JMP18 CS signal from J2A-1 is routed to drive the SYNC signal of the DAC8564/65.
FSX signal from J2A-7 is routed to drive the SYNC signal of the DAC8564/65.
The DAC8564/65 evaluation module schematic appears on the following page.
SLAU252 – June 2008 DAC8564/65 Evaluation Module 23
Submit Documentation Feedback