Datasheet

1 3
1 3
1 3
1 3
1 3
1 3
1 3
1 3
1 3
1 3
1 3
1 3
1 3
1 3
Legend: indicates the corresponding pins that are shorted or closed
3.6 Schematic
www.ti.com EVM Operation
Table 8. Jumper Setting Function (continued)
Reference Jumper Function
Setting
JMP13 Routes V
OUT
to J4-6.
Routes V
OUT
to J4-14.
JMP14 Routes V
OUT
to J4-8.
Routes V
OUT
to J4-16.
JMP15 This jumper position selects the J4A-1 pin of the output terminal, J4A, to route to the noninverting
input of the operational amplifier, U2.
Disconnects the noninverting input of the operational amplifier, U2, from the output terminal, J4A.
This jumper position selects the J4A-3 pin of the output terminal, J4A, to route to the noninverting
input of the operational amplifier, U2.
JMP16 This jumper position selects the operational amplifier, U2, output pin to route to the J4A-5 output
terminal.
Disconnects the operational amplifier’s, U2, output pin from the output terminal of J4A.
This jumper position selects the operational amplifier, U2, output pin to route to the J4A-7 output
terminal.
JMP17 +5-VD (VDD) digital supply is selected for IOVDD.
+3.3-VD digital supply is selected for IOVDD.
JMP18 CS signal from J2A-1 is routed to drive the SYNC signal of the DAC8164/65.
FSX signal from J2A-7 is routed to drive the SYNC signal of the DAC8164/65.
The DAC8164/65 evaluation module schematic appears on the following page.
SLAU256 – August 2008 DAC8164/65 Evaluation Module 15
Submit Documentation Feedback