Datasheet

LP3985
DAC101S101
DIN
SCLK
SYNC
V
OUT
= 0V to 5V
1 PF
0.1 PF
Input
Voltage
0.01 PF
DAC101S101, DAC101S101-Q1
SNAS321F –JUNE 2005–REVISED MARCH 2013 www.ti.com
The minimum resistor value in the circuit of Figure 44 should be chosen such that the maximum current through
the LM4050 does not exceed its 15 mA rating. The conditions for maximum current include the input voltage at
its maximum, the LM4050 voltage at its minimum, the resistor value at its minimum due to tolerance, and the
DAC101S101 draws zero current. The maximum resistor value must allow the LM4050 to draw more than its
minimum current for regulation plus the maximum DAC101S101 current in full operation. The conditions for
minimum current include the input voltage at its minimum, the LM4050 voltage at its maximum, the resistor value
at its maximum due to tolerance, and the DAC101S101 draws its maximum current. These conditions can be
summarized as
R(min) = ( V
IN
(max) − V
Z
(min) / (I
A
(min) + I
Z
(max))
where
• V
Z
(min) are the nominal LM4050 output voltages ± the LM4050 output tolerance over temperature
• I
Z
(max) is the maximum allowable current through the LM4050
• I
A
(min) is the minimum DAC101S101 supply current (3)
and
R(max) = ( V
IN
(min) − V
Z
(max) / (I
A
(max) + I
Z
(min) )
where
• V
Z
(max) are the nominal LM4050 output voltages ± the LM4050 output tolerance over temperature
• I
Z
(min) is the minimum current required by the LM4050 for proper regulation
• I
A
(max) is the maximum DAC101S101 supply current (4)
LP3985
The LP3985 is a low noise, ultra low dropout voltage regulator with a 3% accuracy over temperature. It is a good
choice for applications that do not require a precision reference for the DAC101S101. It comes in 3.0V, 3.3V and
5V versions, among others, and sports a low 30 µV noise specification at low frequencies. Since low frequency
noise is relatively difficult to filter, this specification could be important for some applications. The LP3985 comes
in a space-saving 5-pin SOT-23 and 5-bump micro SMD packages.
Figure 45. Using the LP3985 regulator
An input capacitance of 1.0µF without any ESR requirement is required at the LP3985 input, while a 1.0µF
ceramic capacitor with an ESR requirement of 5mΩ to 500mΩ is required at the output. Careful interpretation
and understanding of the capacitor specification is required to ensure correct device operation.
LP2980
The LP2980 is an ultra low dropout regulator with a 0.5% or 1.0% accuracy over temperature, depending upon
grade. It is available in 3.0V, 3.3V and 5V versions, among others.
18 Submit Documentation Feedback Copyright © 2005–2013, Texas Instruments Incorporated
Product Folder Links: DAC101S101 DAC101S101-Q1