Datasheet


  
  
SCCS041B – SEPTEMBER 1994 – REVISED SEPTEMBER 2001
2
POST OFFICE BOX 655303 • DALLAS, TEXAS 75265
FUNCTION TABLE
INPUTS
OUTPUT
OE
A
OE
B
D
OUTPUT
L
L
H
L
L
H
L
H
X
L
H
Z
H = High logic level, L = Low logic level,
X = Don’t care, Z = High-impedance state
logic diagram (positive logic)
D
1
D
2
D
3
3
4
5
O
1
O
2
O
3
17
16
15
D
4
D
5
D
6
D
7
6
7
8
9
O
4
O
5
O
6
O
7
14
13
12
11
D
0
2
O
0
18
19
1
OE
B
OE
A
absolute maximum rating over operating free-air temperature range (unless otherwise noted)
†
Supply voltage range to ground potential –0.5 V to 7 V. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
DC input voltage range –0.5 V to 7 V. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
DC output voltage range –0.5 V to 7 V. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
DC output current (maximum sink current/pin) 120 mA. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Package thermal impedance, q
JA
(see Note 1): Q package 68°C/W. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
SO package 58°C/W. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Ambient temperature range with power applied, T
A
–65°C to 135°C. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Storage temperature range, T
stg
–65°C to 150°C. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
†
Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only, and
functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not implied.
Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
NOTE 1: The package thermal impedance is calculated in accordance with JESD 51-7.