User's Manual
Table Of Contents
- Table of Contents
- Preface
- 1 eZ430-Chronos™ Overview
- 2 Getting Started
- 3 eZ430-Chronos Software
- 3.1 Overview
- 3.2 eZ430-Chronos Sports Watch Software
- 3.2.1 Detailed Feature Overview - Modes Using the Top LCD Line
- 3.2.1.1 Time Mode
- 3.2.1.2 Alarm Mode
- 3.2.1.3 Temperature Mode
- 3.2.1.4 Altimeter Mode
- 3.2.1.5 Heart Rate Mode - RF Additional accessory or eZ430-Chronos Control Center heart rate simulation required.
- 3.2.1.6 Speed Mode - RF Additional accessory or eZ430-Chronos Control Center heart rate simulation required.
- 3.2.1.7 Tilt Mode
- 3.2.2 Detailed Feature Overview - Modes Using the Bottom LCD Line
- 3.2.2.1 Date Mode
- 3.2.2.2 Stopwatch Mode
- 3.2.2.3 Battery Voltage Mode
- 3.2.2.4 Acceleration Mode - RF
- 3.2.2.5 PowerPoint Mode - RF
- 3.2.2.6 Sync Mode - RF
- 3.2.2.7 Calorie/Distance Mode - RF Additional accessory or eZ430-Chronos Control Center heart rate simulation required.
- 3.2.2.8 Wireless Update - RF
- 3.2.2.9 Chronos-to-Chronos (C2C) Mode
- 3.2.1 Detailed Feature Overview - Modes Using the Top LCD Line
- 3.3 eZ430-Chronos Control Center PC Software
- 3.4 eZ430-Chronos Watch Data Logger
- 3.5 Data Logger PC Software
- 3.6 eZ430-Chronos Software Projects
- 4 eZ430-Chronos Hardware
- 4.1 Programming/Reprogramming the eZ430-Chronos Watch: Disassembly and Assembly of the Housing
- 4.2 Functional Description of the eZ430-Chronos Watch
- 4.3 Functional Description of the eZ430-Chronos RF Access Point
- 4.4 Functional Description of the eZ430-Chronos Debug Interface
- 4.5 Schematics, Layout, BOM, and LCD
- 4.6 Access Point Schematics, Layout and BOM
- A Frequently Asked Questions
- B Detailed Hardware Driver Installation Guide
- Important Notices
www.ti.com
Programming/Reprogramming the eZ430-Chronos Watch: Disassembly and Assembly of the Housing
Figure 4-5. Metal Strips of Watch Housing and Buttons of Housing
CAUTION
Be careful when inserting the watch module. Do not push in the watch module
or tighten the screws without checking if the module is in position. The metal
strips of the buttons may get stuck at the buttons of the watch housing. If this
happens, gently push the strips towards the module with the screwdriver until
they slide over the buttons (see Figure 4-6).
Figure 4-6. Push Metal Strips Inward
3. Ensure that the gasket is in its position and replace the back with the screws again. Try using the
existing thread in the plastic housing and do not over tighten the screws.
61
SLAU292D–November 2009–Revised March 2011 eZ430-Chronos Hardware
Submit Documentation Feedback
Copyright © 2009–2011, Texas Instruments Incorporated