Datasheet

A Step by Step Guide on Updating the TUSB3210 Firmware for I2C communication on the CDCM6208 EVM

www.ti.com

Figure 4. EVM SW4 Location

NOTE: Once the board is powered up, turn SW4 back to the ON position to enable communication

between the EEPROM and the TUSB3210 chip. The board is now ready for programming.

Step 2 – Using the TI EEPROM Burner Software

To use the EEPROM Burner Software, simply boot up the program and appropriately fill out the pull down

menus. If the CDCM6208 EVM is recognized by the Burner software and driver, an option under the

“Select the USB Device:” should appear named “TI TUSB3210 EEPROMBurner”. This indicates the driver

has successfully connected to the TUSB3210 on the CDCM6208 EVM.

The EVM features 512kbits of EEPROM, so select this option on the ”Select EEPROM Size:” drop down

menu. Finally, locate the location of the new firmware .BIN file. Use the Browse button near the “Select

EEPROM Image:” to locate the .BIN file location. A screenshot of the Burner software is provided in

Figure 5.

CDCM6208 Evaluation Board SCAU049A–May 2012–Revised January 2013

Submit Documentation Feedback