User Manual

Confidential
Manual Carrier Controller 2020-07-30
SPD6752150121R21_EN.docx Page 9 of 25
Table 3-8: Approved mating parts X104
Manufacturer
Mfr. PN
Type
Description / Conditions
Remarks
Beumer
196675
Cable
Beumer Fieldbus cable
Various lengths available, Mfr PN
(196675) is followed by the length
in cm separated by a “.”
3.5. Connector X105
Type: Fieldbus OUT
Connector type: M12 8p Female A-Type, Phoenix 1457678
Hot swappable: No
Voltage class: DVC-B / Potential hazardous voltage, not isolated from DC-input
Cable voltage rating: ≥125 V
Shielding: Connector shield connected to housing
Label: X105
Torque requirement: 0.6 Nm
ATTENTION! Type 5 enclosure rating is only achieved when approved mating parts are used as
shown in the Approved mating parts table below
ATTENTION! Before connecting or disconnecting X105 the power must be switched off.
Table 3-9: Connector X105
Pin
I/O
Mnemonic
Description / Conditions
Pair
1
I/O
SL_H
Proprietary half duplex differential interface
A
2
I/O
SL_L
Proprietary half duplex differential interface
3
O
M_TX_P
Proprietary full duplex differential interface
B
4
O
M_TX_N
Proprietary full duplex differential interface
5
I
M_RX_P
Proprietary full duplex differential interface
C
6
I
M_RX_N
Proprietary full duplex differential interface
7
PWR
+15V_FBO
MCC: Positive supply output (+15V, 1A)
SCC: connection to X104p7
D
8
PWR
GND
MCC: Negative supply output (+15V, 1A)
SCC: connection to X104p8
Table 3-10: Approved mating parts X105
Manufacturer
Mfr. PN
Type
Description / Conditions
Remarks
Phoenix
1414148
Sealing cap
PROT-M12 MS-M
Beumer
196675
Cable
Beumer Fieldbus cable
Various lengths available, Mfr PN
(196675) is followed by the length
in cm separated by a “.”
3.6. Connector X106
Type: WLAN
Connector type: RP-SMA
Shielding: Connector shield connected to housing
Voltage class: DVC-A
Cable voltage rating: n/a
Hot swappable: No
Label: X106
ATTENTION! Cables connected to X106 and X107 (DVC-A/ELV circuit) must be routed separate
from cabling to X100,X102,X103,X104,X105,X108 and X109 ( DVC-B and DVC-C
circuit).
Table 3-11: Connector X106
Pin
I/O
Mnemonic
Description / Conditions
1
I
ANT
WLAN antenna
C
I
Chassis
Connected to GND_PELV