User Manual

Confidential
Manual Carrier Controller 2020-07-30
SPD6752150121R21_EN.docx Page 13 of 25
4. Installation
This chapter specifies the installation requirements of the Carrier Controller.
4.1. Mounting
See Figure 4-1. The Carrier Controller shall be mounted on a flat surface capable of carrying the
mass of the Carrier Controller plus all attached cables. The Carrier Controller shall be fixed to the
mounting surface through zinc-plated steel M6 screws using mounting holes 1, 2, 5, and 6 as
indicated in the detail in the top-right of Figure 4-1. Mounting holes 3 and 4 are optional, and are
recommended for use in environments with high vibration levels.
It is recommended to use M6 zinc-plated steel washers or similar geometry at the M6 screw hole
locations on the mounting surface to keep Carrier Controller bottom and mounting surface
separated.
Figure 4-1: Mounting of the Carrier Controller