User Manual

Confidential
Manual Carrier Controller 2020-07-30
SPD6752150121R21_EN.docx Page 10 of 25
3.7. Connector X107
Type: Ethernet
Connector type: M12 8p Female X-Type, Phoenix 1402457
Shielding: Connector shield connected to housing
Voltage class: DVC-A
Cable voltage rating: n/a
Hot swappable: Yes
Label: X107
Torque requirement: 0.6 Nm
ATTENTION! Type 5 enclosure rating is only achieved when approved mating parts are used as
shown in the Approved mating parts table below
ATTENTION! Cables connected to X106 and X107 (DVC-A/ELV circuit) must be routed separate
from cabling to X100,X102,X103,X104,X105,X108 and X109 ( DVC-B and DVC-C
circuit).
Table 3-12: Connector X107
Pin
I/O
Mnemonic
Description / Conditions
Pair
1
I
Rx+
Positive Receive
A
2
I
Rx-
Negative Receive
3
O
Tx+
Positive Transmit
B
4
O
Tx-
Negative Transmit
5
-
-
-
6
-
-
-
7
-
-
-
8
-
-
-
Table 3-13: Approved mating parts X107
3.8. Connector X108
Type: Motor connection
Connector type: M12 4p Female S-Power, Phoenix 1406409
Shielding: Connector shield connected to housing and PIN
Voltage class: DVC-C / Potential hazardous voltage, not isolated from DC-input
Cable voltage rating: ≥125 V
Hot swappable: No
Label: X108
Torque requirement: 0.6 Nm
ATTENTION! The Carrier Controller units do not provide safety grounding for the external motor
installed on connector X108. The grounding provision on X108 is only intended for
functional grounding purposes. The safety grounding/bonding of the motor shall
occur separately from the Carrier Controller units in accordance with the
requirements of the applicable Electrical codes/Standards.
The chassis of the Carrier Controller units is to be grounded through Protective
earth connection as defined in this Instruction manual. The incoming safety
grounding provision is not part of the Carrier Controller units and needs to be
evaluated in the end use application.
ATTENTION! Failure to correctly connect the protective earth of the motor can result in a safety
hazard.
Manufacturer
Mfr. PN
Type
Description / Conditions
Remarks
Phoenix
1414148
Sealing cap
PROT-M12 MS-M
Phoenix
Various
Cable
Network cable
VS-M12MSS-IP20-94F
Various lengths available
For example 15m (Mfr PN 1440643)