User's Guide
Table Of Contents
- CC3235MODSF SimpleLink™ Wi-Fi® and IoT Solution With MCU LaunchPad™ Hardware
- Table of Contents
- 1 Introduction
- 2 Hardware
- 2.1 Block Diagram
- 2.2 Hardware Features
- 2.2.1 Key Benefits
- 2.2.2 XDS110-Based Onboard Debug Probe
- 2.2.3 Debug Probe Connection: Isolation Jumper Block
- 2.2.4 Application (or "Backchannel") UART
- 2.2.5 JTAG Headers
- 2.2.6 Using the XDS110 Debug Probe with a Different Target
- 2.2.7 Power Connections
- 2.2.8 Reset Pullup Jumper
- 2.2.9 Clocking
- 2.2.10 I2C Connection
- 2.2.11 Sense on Power (SOP)
- 2.2.12 Push-Buttons and LED Indicators
- 2.3 Electrical Characteristics
- 2.4 Antenna Characteristics
- 2.5 BoosterPack™ Header Pin Assignment
- 3 Layout Guidelines
- 4 Operational Setup and Testing
- 5 Development Environment Requirements
- 6 Additional Resources
- 7 Assembly Drawing and Schematics
- Revision History
- Important Notice
TI Confidential – NDA Restrictions
www.ti.com
3
SWRU548A–February 2019
Submit Documentation Feedback
Copyright © 2019, Texas Instruments Incorporated
Contents
3.1 FCC....................................................................................................................... 49
3.2 CAN ICES-3(B) and NMB-3(B) Certification and Statement...................................................... 50
3.3 End Product Labeling .................................................................................................. 51
3.4 Device Classifications.................................................................................................. 51
3.5 FCC Definitions ......................................................................................................... 51
3.6 Simultaneous Transmission Evaluation.............................................................................. 52
4 EU Certification and Statement ............................................................................................ 52
4.1 RF Exposure Information (MPE)...................................................................................... 52
4.2 Simplified DoC Statement ............................................................................................. 52
4.3 Waste Electrical and Electronic Equipment (WEEE)............................................................... 53
4.4 OEM and Host Manufacturer Responsibilities ...................................................................... 53
4.5 Antenna Specifications................................................................................................. 53
5 CC3235MODx Approved Antennas ....................................................................................... 53