User's Guide
Table Of Contents
- CC3235MODSF SimpleLink™ Wi-Fi® and IoT Solution With MCU LaunchPad™ Hardware
- Table of Contents
- 1 Introduction
- 2 Hardware
- 2.1 Block Diagram
- 2.2 Hardware Features
- 2.2.1 Key Benefits
- 2.2.2 XDS110-Based Onboard Debug Probe
- 2.2.3 Debug Probe Connection: Isolation Jumper Block
- 2.2.4 Application (or "Backchannel") UART
- 2.2.5 JTAG Headers
- 2.2.6 Using the XDS110 Debug Probe with a Different Target
- 2.2.7 Power Connections
- 2.2.8 Reset Pullup Jumper
- 2.2.9 Clocking
- 2.2.10 I2C Connection
- 2.2.11 Sense on Power (SOP)
- 2.2.12 Push-Buttons and LED Indicators
- 2.3 Electrical Characteristics
- 2.4 Antenna Characteristics
- 2.5 BoosterPack™ Plug-in Module Pinout
- 3 Layout Guidelines
- 4 Operational Setup and Testing
- 5 Development Environment Requirements
- 6 Additional Resources
- 7 Assembly Drawing and Schematics
- Appendix A Manual Information to the End User
- Revision History
- Important Notice
TI Confidential – NDA Restrictions
Revision History
www.ti.com
54
SWRU548A–February 2019–Revised August 2019
Submit Documentation Feedback
Copyright © 2019, Texas Instruments Incorporated
Revision History
Revision History
NOTE: Page numbers for previous revisions may differ from page numbers in the current version.
Changes from Original (February 2019) to A Revision .................................................................................................. Page
• Updated CC3235MODSF SimpleLink ™ Wi-Fi
®
LaunchPad™ Development Kit image. ........................................ 5
• Added note to CC3220 LaunchPad™ section......................................................................................... 6
• Added REACH Compliance section..................................................................................................... 7
• Added last paragraph to Section 1.6.2 ................................................................................................. 8
• Updated CC3235MODSF LaunchPad™ EVM Overview image................................................................... 10
• Changed Hibernate Current from 5 µA to 5.5 µA.................................................................................... 15
• Updated 5-GHz TX Power at 6 OFDM to 15.1 dBm. ............................................................................... 15
• Updated BoosterPack™ Plug-in Module Pinout section............................................................................ 27
• Updated Pin 1 Marking on LaunchPad (3V3 Mark) image. ........................................................................ 37
• Updated Low Current Measurement image. ......................................................................................... 38
• Updated Using Onboard Antenna (Default Condition) image...................................................................... 40
• Updated Board Modified for External Antenna Connections (Measure 2.4 GHz or 5 GHz) image. .......................... 40
• Added Section 6.3 ....................................................................................................................... 42
• Updated CC32xx SimpleLink™ Academy image. ................................................................................... 42
• Updated LAUNCHCC3235MOD Top-Layer Assembly Drawing................................................................... 43
• Updated Schematics..................................................................................................................... 44
• Added Manual Information to the End User appendix. ............................................................................. 49