User manual

www.ti.com

List of Figures

1 CC3200 LaunchPad EVM Overview ...................................................................................... 5

2 CC3200 Block Diagram ..................................................................................................... 6

3 Pn-1 Marking on the LaunchPad (white triangle)........................................................................ 7

4 JTAG Headers ............................................................................................................... 7

5 I2C Connections ............................................................................................................. 8

6 UART Signals ................................................................................................................ 9

7 SOP Jumpers............................................................................................................... 10

8 2x20 Pin Connector ....................................................................................................... 14

9 Powering From USB ....................................................................................................... 15

10 Battery Power............................................................................................................... 16

11 Measuring Low Power ..................................................................................................... 17

12 Measuring Active Power................................................................................................... 18

13 Radiated Testing Using Chip Antenna .................................................................................. 19

14 Board Set for Conducted Testing ........................................................................................ 19

List of Tables

1 JTAG Headers ............................................................................................................... 8

2 Jumper Settings.............................................................................................................. 8

3 Default I2C Addresses ...................................................................................................... 9

4 Jumper Settings.............................................................................................................. 9

5 UART Signals ................................................................................................................ 9

6 SOP Lines................................................................................................................... 10

7 Miscellaneous Settings .................................................................................................... 11

8 Push Buttons................................................................................................................ 12

9 LEDs ......................................................................................................................... 13

10 Change Log ................................................................................................................. 20

SWRU372–June 2014 List of Figures

Submit Documentation Feedback