User manual

www.ti.com

Hardware Description

Table 9. LEDs

Refere

nce Colo4 Usage Comments

D1 Yellow nRESET This LED is used to indicate the state of nRESET pin. If this LED is

glowing, the device is functional.

D2 Green Debug This LED glows whenever the debugging it enabled over the JTAG

D4 RED Power Indicates when the 3.3 V power is supplied to the board.

D5 GREEN GPIO_11

(1)

Glows when the GPIO is logic-1

D6 YELLOW GPIO_10

(1)

Glows when the GPIO is logic-1

D7 RED GPIO_09 Glows when the GPIO is logic-1

(1)

GPIO_10 and GPIO_11 are used as I2C also. So whenever the pull-ups are enabled, the LEDs would glow.

SWRU372–June 2014 CC3200 SimpleLink™ Wi-Fi

and IoT Solution with MCU LaunchPad

Hardware

Submit Documentation Feedback