User manual

Hardware Description

www.ti.com

2.4.7 Push Buttons and LEDs

Table 8. Push Buttons

Reference Usage Comments

SW1 RESET This is used to RESET the CC3200 device. This signal is also output on

the 20-pin connector to RESET any external BoosterPack which may be

stacked.

SW2 GPIO_22 When pushed, the GPIO_22 will be pulled to VCC.

SW3 GPIO_13 When pushed, the GPIO_13 will be pulled to VCC.

CC3200 SimpleLink™ Wi-Fi

and IoT Solution with MCU LaunchPad SWRU372–June 2014

Hardware

Submit Documentation Feedback