User manual

Table Of Contents

www.ti.com

Compile, Download, and Debug

6. Run the following command:

./configure --enable-maintainer-mode --disable-werror --disable-shared --enable-ft2232_ftd2xx -

-with-ftd2xx-win32-zipdir=ftd2xx

The command should look similar to Figure 25.

Figure 25. Cygwin Terminal

The last lines of the result should appear as in Figure 26.

Figure 26. Cygwin Terminal

7. Run the command ‘autoreconf --force --install.'

8. Run the command ‘make.’ This may take several minutes. The last lines of the result should appear as

in Figure 27.

Figure 27. Running the Make Command

9. Run the command ‘make install.’ The last lines of the result should appear as in Figure 28.

SWRU376A–June 2014–Revised June 2014 CC3200 SimpleLink™ Wi-Fi

and IoT Solution With MCU LaunchPad™

Getting Started Guide

Submit Documentation Feedback