User's Manual


ManualInformationtotheEndUser
TheOEMintegratormustbeawarenottoprovideinformationtotheenduserregardinghowtoinstall
orremovethisRFmoduleintheuser’smanualoftheendproductwhichintegratesthismodule.
Theendusermanualmustincludeallrequiredregulatoryinformation/warningasshowninthismanual.
1. RFFunctionandFrequencyRange
TheCC3120MODRNMMOBisdesigntooperateintheWLAN2.4GHzband.TheCC3120MODRNMMOB
supportsthefollowingchannelsdependentontheregionofoperation:
 FCC/IC:Channels1through11(2142MHzto2462MHz)
 EU:Channels1throug h13(2142MHzto2472MHz)
 JP:Channels1
through13(2142MHzto2472MHz)
NotethattheCC3220MODxandCC3220MODAxdonotsupportdeterminationofitsregionthruany
externalmechanism.TheregionissetbytheapplicationSWoratthetimeofprogrammingofthe
device.Theenduserisunabletochangetheregion
ofoperationatanytime.

NOTE:

ThemaximumRFpowertransmitted ineachWLAN2.4GHzbandis18dBm.

2. FCC/ICCertificationandStatement
Thisdeviceisinten dedforOEMintegratorsunderthefollowingconditions:
 Theantennamustbeinstalledsuchthat20cmismaintainedbetweentheantennaanduser s,
 Thetransmittermodulemaynotbeco‐locatedwithanyothertransmitterorantenna.
 TocomplywithFCC/ICregulations
limitingboth maximumRFoutputpower andhuman
exposuretoRFradiation,themaximumantenna gainincludingcablelossinamobileexposure
conditionmustnotexceed:
 2.5dBiinWLAN2.4G
Intheeventthattheseconditionscannotbemet(forexample certainlaptopconfigurationsorco‐
location
withanothertransmitter),thentheFCC/ICauthorization isnolongerconsideredvalidandthe
FCC/ICIDcannotbeusedonthefinalproduct.Inthesecircumstances,theOEMintegratorwillbe
responsibleforre‐evaluatingtheendproduct(includingthetrans mitter)andobtainingaseparateFCC/

ICauthorization.