User's Manual

CC3100BOOST User Guide

TI Proprietary Information - Strictly Private

GPIO_08.

LED glows when GPIO_08 goes low.

nHIB

Green LED

Glows when the CC3100 device is

enabled using nHIB.

Power

RED LED to indicate the power line

status.

Note : This LED can glow if the board is

powered from any of the GPIO being

high, and the Vcc is un-connected. This

is not a valid state and should be

avoided.

3.6 Conducted testing

The board is by default configured for radiated measurement using the on-board chip

antenna. For conducted testing in the lab the following changes needs to be done on the

board.

Mode

Change

Image

Conducted test

using U.FL

C4 = 10pF

C2 = DNP