User's Manual
CC3100BOOST User Guide
TI Proprietary Information - Strictly Private
part with 3.3V LDO.
Install this for all boards with the
CC3100Z parts.
J2
Sense on power
Sense on power used for internal debug.
SOP[2:0] = 000 [Functional 4W]
SOP[2:0] = 001 [Functional 2W]
SOP[2:0] = 010 [Load from EEPROM]
SOP[2:0] = 011 [Boot Debug mode]
SOP[2:0] = 100 [UART LOAD]
SOP[2:0] = 101 [TESTMODE 3]
SOP[2:0] = 110 [TESTMODE 2]
SOP[2:0] = 111 [TESTMODE 1]
J1
RF Test
U.FL connector for conducted testing.
3.5 LED and switches
Reference
Usage
Comments
SW1
RESET
Reset the CC3100 when mated with the
LP or FTDI board. Useful while updating
the flash contents.
SW2
OOB Demo
Pull GPIO_13 to Vcc when pressed.
D1
GPIO_09
Yellow LED to indicate state of GPIO_09.
LED glows when GPIO_09 goes low.
D2
GPIO_08
GREEN LED to indicate state of