User's Manual

CC3100BOOST User Guide
TI Proprietary Information - Strictly Private
FIGURE 1 : HARDWARE DETAILS
3.2 Board features
 2x20 pin stackable connectors
 On-board chip antenna with option for U.FL based conducted testing.
 Power from on-board LDO using USB OR 3.3V from MCU Launchpad
 Push buttons (2x)
 LEDs (4x)
 Jumper with 0.1 Ohm resistor for current measurement.
 .8 Mbit serial flash
 40 MHz crystal , 32KHz crystal and oscillator.
CC3100
RESET
Current
Measurement
RESET
BUTTON
Sense on
Power
GPIO13
U.FL
Antenna
RF SIGNAL
SELECT
TOP DIE
FLASH Vcc
CC3100 Vcc
GPIO12
USB CONN
SERIAL
FLASH