User's Manual

CC3100BOOST User Guide

TI Proprietary Information - Strictly Private

VCP

COM port for flash

programming

VCP

RT3

For RF debug using RT3

software

Note : On the PC only two of the four ports would be visible on the Device Manager. The

D2XX ports are not listed under the “Ports” tab.

The first COM port in the list usually is used for the flash programming.

Ports available on J2

Port No

Port Type

Usage

Comments

VCP

MAC logg UART Tx for

WLAN Debug

VCP

NWP log UART Tx for

debugging

4.3.3 Driver requirements

The FTDI Debug board requires the user to install the associated drivers on a PC. This

package is available as part of the SDK release and would be located at [Install-

Path]\cc3100-sdk\tools\cc31xx_board_drivers\.

The install path is usually C:\ti\cc3100SDK

For SL_Prog