User's Manual

CC3100BOOST User Guide
TI Proprietary Information - Strictly Private
Radiated test
using antenna
C4 = DNP
C2 = 10pF
Note : The 10pF capacitor used should be of RF grade with high-Q to reduce the overall
loss. Otherwise a 0 Ohm resistor can also be used for this.
3.7 Current measurement
The board provides a jumper connected to a 0.1 Ohm resistor for current measurement. The
measurement is made by using a voltmeter across the jumper and multiplying the value
obtained in mV by 10 to get the current in mA. The current measurement jumper is J24 as
shown in Figure 1.
Note : The measurement may have up to 10% error due to resistor variation and contact
resistance due to reflow soldering.