Datasheet

CC3100

www.ti.com

SWAS031D –JUNE 2013–REVISED FEBRUARY 2015

• Host goes to sleep but the UART module has receiver start-edge detection for auto wakeup and does

not lose data.

• Host can always receive any amount of data transmitted by the SimpleLink device because there is no

flow control in this direction.

Because there is no full flow control, the host cannot stop the SimpleLink device to send its data; thus, the

following parameters must be carefully considered:

• Max baud rate

• RX character interrupt latency and low-level driver jitter buffer

• Time consumed by the user's application

Submit Documentation Feedback

Product Folder Links: CC3100