User manual

www.ti.com Factory Configuration (FCFG)
9.2.1.64 AMPCOMP_TH2 Register (Offset = 374h) [reset = X]
AMPCOMP_TH2 is shown in Figure 9-85 and described in Table 9-87.
Ampltude Compensation Threashold 2
Figure 9-85. AMPCOMP_TH2 Register
31 30 29 28 27 26 25 24
LPMUPDATE_LTH RESERVED
R-1Ah R-3h
23 22 21 20 19 18 17 16
LPMUPDATE_HTM RESERVED
R-22h R-3h
15 14 13 12 11 10 9 8
ADC_COMP_AMPTH_LPM RESERVED
R-X R-3h
7 6 5 4 3 2 1 0
ADC_COMP_AMPTH_HPM RESERVED
R-X R-3h
Table 9-87. AMPCOMP_TH2 Register Field Descriptions
Bit Field Type Reset Description
31-26 LPMUPDATE_LTH R 1Ah
LPM Update low amplitude threshhold. if amp > LPMUPDATE_LTH
&& amp < LPMUPDATE_HTH then move on.
25-24 RESERVED R 3h
Software should not rely on the value of a reserved. Writing any
other value than the reset value may result in undefined behavior.
23-18 LPMUPDATE_HTM R 22h
LPM Update high amplitude threshhold. if amp > LPMUPDATE_LTH
&& amp < LPMUPDATE_HTH then move on.
17-16 RESERVED R 3h
Software should not rely on the value of a reserved. Writing any
other value than the reset value may result in undefined behavior.
15-10 ADC_COMP_AMPTH_LP R X
When ADC is forced in comparator mode, this value is used as
M
OPAMP's threshold during LPM_UPDATE mode. Actual amplitude is
compared against this threshhold to generate 1-bit
adc_threshholdmet indicator output.
9-8 RESERVED R 3h
Software should not rely on the value of a reserved. Writing any
other value than the reset value may result in undefined behavior.
7-2 ADC_COMP_AMPTH_HP R X
When ADC is forced in comparator mode, this value is used as
M
OPAMP's threshold during HPM_UPDATE mode. Actual amplitude is
compared against this threshhold to generate 1-bit
adc_threshholdmet indicator output.
1-0 RESERVED R 3h
Software should not rely on the value of a reserved. Writing any
other value than the reset value may result in undefined behavior.
781
SWCU117A–February 2015–Revised March 2015 Device Configuration
Submit Documentation Feedback
Copyright © 2015, Texas Instruments Incorporated