User manual

Factory Configuration (FCFG) www.ti.com
9.2.1.63 AMPCOMP_TH1 Register (Offset = 370h) [reset = FF7B828Eh]
AMPCOMP_TH1 is shown in Figure 9-84 and described in Table 9-86.
Ampltude Compensation Threashold 1
Figure 9-84. AMPCOMP_TH1 Register
31 30 29 28 27 26 25 24
RESERVED
R-FFh
23 22 21 20 19 18 17 16
HPMRAMP3_LTH RESERVED
R-1Eh R-3h
15 14 13 12 11 10 9 8
HPMRAMP3_HTH IBIASCAP_LPTOHP_OL_CNT
R-20h R-Ah
7 6 5 4 3 2 1 0
IBIASCAP_LPTOHP_OL_CNT HPMRAMP1_TH
R-Ah R-Eh
Table 9-86. AMPCOMP_TH1 Register Field Descriptions
Bit Field Type Reset Description
31-24 RESERVED R FFh
Software should not rely on the value of a reserved. Writing any
other value than the reset value may result in undefined behavior.
23-18 HPMRAMP3_LTH R 1Eh
HPM Ramp3 low amplitude threshhold. In HPM_RAMP3, if amp >
HPMRAMP3_LTH & & amp < HPMRAMP3_HTH then move on
HPM_UPDATE.
17-16 RESERVED R 3h
Software should not rely on the value of a reserved. Writing any
other value than the reset value may result in undefined behavior.
15-10 HPMRAMP3_HTH R 20h
In HPM_RAMP3, if amp > HPMRAMP3_LTH && amp <
HPMRAMP3_HTH then move on to HPM_UPDATE.
9-6 IBIASCAP_LPTOHP_OL_ R Ah
During XOSC mode transition, CAP trim and IBIAS trim should be
CNT
modified by this amount. IBIAS and CAP trim open loop count.
CAP_REM is remainder of the CAP that is left to reach the final cap
value.
5-0 HPMRAMP1_TH R Eh
During XOSC mode transition, CAP trim and IBIAS trim should be
modified by this amount. IBIAS and CAP trim open loop count.
CAP_REM is remainder of the CAP that is left to reach the final cap
value.
780
Device Configuration SWCU117A–February 2015–Revised March 2015
Submit Documentation Feedback
Copyright © 2015, Texas Instruments Incorporated