User manual

AUX – Sensor Controller Registers

www.ti.com

17.8.5.5 T1TARGET Register (Offset = 10h) [reset = X]

T1TARGET is shown in Figure 17-54 and described in Table 17-76.

Timer 1 Target Target Counter Value Timer 1

Figure 17-54. T1TARGET Register

31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0

RESERVED VALUE

R-X R/W-X

Table 17-76. T1TARGET Register Field Descriptions

Bit Field Type Reset Description

31-8 RESERVED R X

Software should not rely on the value of a reserved. Writing any

other value than the reset value may result in undefined behavior.

7-0 VALUE R/W X

Timer 1 counts from 0 to VALUE. Then gives an event and restarts if

configured to do to so in the T1CFG.RELOAD setting. If VALUE is

changed while timer 1 is running so that the count becomes higher

than VALUE timer 1 will also restart if configured to do so. If

T1CFG.MODE=0,no prescaler is used, and VALUE equals 1, the

TIMER1_EV event line will be always set

1280

AUX – Sensor Controller with Digital and Analog Peripherals SWCU117A–February 2015–Revised March 2015

Submit Documentation Feedback