User manual

www.ti.com

AUX – Sensor Controller Registers

17.8.5.4 T0TARGET Register (Offset = Ch) [reset = X]

T0TARGET is shown in Figure 17-53 and described in Table 17-75.

Timer 0 Target Target counter value for timer 0

Figure 17-53. T0TARGET Register

31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0

RESERVED VALUE

R-X R/W-X

Table 17-75. T0TARGET Register Field Descriptions

Bit Field Type Reset Description

31-16 RESERVED R X

Software should not rely on the value of a reserved. Writing any

other value than the reset value may result in undefined behavior.

15-0 VALUE R/W X

Timer 0 counts from 0 to VALUE. Then gives an event and restarts if

configured to do to so in the T0CFG.RELOAD setting. If VALUE is

changed while timer 0 is running so that the count becomes higher

than VALUE timer 0 will also restart if configured to do so. If

T0CFG.MODE=0,no prescaler is used, and VALUE equals 1, the

TIMER0_EV event line will be always set

1279

SWCU117A–February 2015–Revised March 2015 AUX – Sensor Controller with Digital and Analog Peripherals

Submit Documentation Feedback