User manual

www.ti.com Cortex-M3 Processor Registers
2.7.3.10 COMP7 Register (Offset = 24h) [reset = X]
COMP7 is shown in Figure 2-70 and described in Table 2-95.
Comparator 7
Figure 2-70. COMP7 Register
31 30 29 28 27 26 25 24
REPLACE RESERVED COMP
R/W-X R/W-X R/W-X
23 22 21 20 19 18 17 16
COMP
R/W-X
15 14 13 12 11 10 9 8
COMP
R/W-X
7 6 5 4 3 2 1 0
COMP RESERVED ENABLE
R/W-X R/W-X R/W-X
Table 2-95. COMP7 Register Field Descriptions
Bit Field Type Reset Description
31-30 REPLACE R/W X
This selects what happens when the COMP address is matched.
Comparator 7 is a literal comparator and the only supported setting
is 0x0. Other settings will be ignored. 0x0: Remap to remap address.
See REMAP.REMAP 0x1: Set BKPT on lower halfword, upper is
unaffected 0x2: Set BKPT on upper halfword, lower is unaffected
0x3: Set BKPT on both lower and upper halfwords.
29 RESERVED R/W X
Software should not rely on the value of a reserved. Writing any
other value than the reset value may result in undefined behavior.
28-2 COMP R/W X
Comparison address.
1 RESERVED R/W X
Software should not rely on the value of a reserved. Writing any
other value than the reset value may result in undefined behavior.
0 ENABLE R/W X
Compare and remap enable comparator 7. CTRL.ENABLE must also
be set to enable comparisons. 0x0: Compare and remap for
comparator 7 disabled 0x1: Compare and remap for comparator 7
enabled
127
SWCU117A–February 2015–Revised March 2015
Submit Documentation Feedback
Copyright © 2015, Texas Instruments Incorporated